Illustink

How to make a tattoo stencil

A good stencil is clean, readable linework at the right size. Here is the whole route, from reference to skin.

1. Start from a clear reference

Use a sharp photo or drawing with good contrast. Crop away anything you will not tattoo, so the stencil only shows what matters. A busy background adds stray lines you will have to remove later.

2. Turn it into linework

You can trace the design by hand, or let a stencil maker do the first pass. In Illustink, upload the photo, pick a style (linework, dots, hatching or blackwork) and adjust the detail until the lines are clean. For a pencil drawing on paper, choose Sketch on paper: the paper texture and loose pencil marks disappear and every stroke becomes one even line.

3. Clean it up

Remove stray specks and lines you do not want with the eraser, and add any missing line with the pen. Less is more: shading is usually better done freehand, so many artists only keep the outlines and a few guide marks.

4. Set the size for the placement

Measure the placement on the client and enter that width in centimetres. Print a test on plain paper and hold it against the body before you print on stencil paper.

5. Print on stencil paper

With a thermal stencil printer or thermal copier, print the PDF or image straight onto thermal stencil paper. Always print at 100% (actual size). Check the 1 cm bar on the printout to make sure nothing was scaled.

6. Apply it

  1. Clean and, where needed, shave the skin.
  2. Apply a thin layer of stencil transfer solution.
  3. Press the stencil on firmly without sliding, then peel it off slowly.
  4. Let the stencil dry before you start tattooing, so it does not wipe away.

Products differ. Always follow the instructions of your stencil paper and transfer solution.

Make your stencil now, freeOpen Illustink →