Illustink

How to make a tattoo stencil without a printer

You do not need a thermal printer to make a good stencil. Hand-tracing on stencil paper works fine, it just takes a little longer.

What you need

1. Prepare a clean line drawing

Make clean linework first, so you only have to trace lines that belong in the tattoo. With Illustink you can turn a photo into linework, set the exact size and print it on any normal home or office printer. Print it at 100% and check the 1 cm bar.

2. Trace onto the stencil paper

  1. Separate the layers as the paper's instructions describe; most papers have a protective tissue sheet that you remove.
  2. Line up your printed design with the white top sheet.
  3. Trace every line firmly and evenly with the pen. The pressure transfers the purple carbon onto the back of the white sheet.
  4. The purple copy on the back of the white sheet is the side that goes on the skin.

3. Check before you apply

Lift a corner to see whether every line came through. Go over faint lines again before you take the sheets apart. Lettering in particular should read the right way round on the skin, so test this once with a small word before you trace a full piece.

Other options

Stencil papers differ. Always follow the instructions that come with your paper.

Make your stencil now, freeOpen Illustink →